Industrial Utility Plant Engineering — Boilers, Chillers & Compressed Air
Turnkey design, supply, installation and commissioning of the complete utility block that powers process plants — steam, refrigeration, compressed air, cooling water and treated water — engineered for uptime and energy efficiency.
Discuss Your RequirementThe Engine Room of Every Process Plant
Steam, refrigeration, compressed air, cooling water and treated water are the silent utilities that decide whether a plant runs at rated capacity or stutters. ATMAN designs, supplies, installs and commissions the complete utility block as one integrated package — sized on a full heat-and-mass balance, built for redundancy, and tuned for the lowest possible energy cost per unit of output.
Utility Systems Under One Roof
Steam & Boilers
IBR and non-IBR boilers, thermic-fluid heaters, steam distribution headers, PRV stations and condensate recovery for maximum fuel efficiency.
Refrigeration & Chilled Water
Ammonia and freon plants, chilled-water and glycol circuits, plate heat exchangers, ice-bank and brine systems for process cooling.
Compressed Air
Oil-free and lubricated compressors, refrigerated and desiccant dryers, receivers, instrument-air and ring-main distribution.
Cooling Towers
Induced and forced-draft towers, condenser-water circuits, side-stream filtration and shell-and-tube or plate exchangers.
Water & Effluent
Softening, RO and DM plants, CIP water systems, pumping and distribution, plus ETP and STP integration.
Utility Controls
Utility MCC and PCC panels, VFD energy optimization and PLC or SCADA monitoring, integrated with the plant automation layer.
Concept to Performance Guarantee
- Heat-and-mass balance and utility load assessment
- Equipment sizing, selection and vendor engineering
- P&IDs, GA drawings and piping isometrics
- Fabrication, erection, insulation and lagging
- Electrical, instrumentation and control integration
- Installation, commissioning and performance testing
- Energy audit and heat-recovery optimization
- Annual maintenance and spares support
Built for Uptime and Efficiency
- Single-window responsibility from design to commissioning
- In-house process, electrical and automation engineering
- Energy-first design — heat recovery, VFDs, condensate return
- N+1 redundancy for critical utilities
- Compliance with IBR, PESO and factory safety norms
- Pan-India installation and after-sales service since 2008
Utility Systems We Build
Planning a new plant or a utility upgrade?
From a single boiler house to a complete utility block, we deliver it engineered, installed and guaranteed.
Request a Consultation